Las Cruces Premium Roofing provides professional fascia & soffit in Las Cruces, NM for residential and commercial properties across the Mesilla Valley. Of everything on a roof, fascia and soffit are what the neighbors notice failing first. In this county they go from sun rather than from rot, and that one difference changes the diagnosis, the repair, and the material we end up recommending.
On a site-built Las Cruces house the fascia board is usually painted wood on the west and south elevations, and the enemy is ultraviolet checking. Paint chalks, the surface opens into fine cracks, water from a monsoon afternoon gets into end grain that has been drying and swelling for years, and the board goes soft at the joints while the middle still looks fine. We probe joints and cut ends rather than trusting the face.
Soffit failure is usually a ventilation problem wearing a cosmetic disguise. Vented soffit panels get painted over, stuffed with insulation from above, or blocked by a later addition, and the attic loses its intake. So we look at soffit and ventilation together, because replacing a rotten panel while leaving the intake blocked just buys you the same repair again in a decade.
Material choice here is not a matter of taste. Painted wood is authentic on older stock and it demands repainting on a real schedule in this sun. Fiber cement holds paint far longer and does not check. Aluminum and vinyl are maintenance-free and can look wrong on a traditional home, and vinyl in particular can sag on a long west-facing run in July heat. We will tell you which of those tradeoffs applies to your elevation.
Manufactured homes do not have fascia and soffit in this sense at all. A HUD-code home has a formed metal eave rail and a bottom closure, and the failure is a fastening and sealant issue rather than a rot issue. Repairing it means addressing the rail and its attachment, not cutting in a board, and anyone who quotes you lumber for that eave has not looked at the house.
The work is usually modest and the cost is usually far below what people brace themselves for. A few boards, a soffit run reopened and rebaffled, primed and painted end grain rather than a fast coat over bare cuts, and the drip edge reset so it actually laps the fascia instead of sitting behind it and pouring water down the back of the board every summer.
Our licensed and insured team brings the right materials and equipment to every job — HUD-code roof pans re-seamed with embedded reinforcing fabric, silicone restoration membrane applied at 22 to 26 dry mils, roof-mounted evaporative cooler curbs with base and counter flashing, 29-gauge exposed-fastener panel refastened to oversize diameter screws, tapered polyisocyanurate cut to a quarter inch per foot with crickets, two-ply granulated modified bitumen over a low-slope valley-floor deck — and backs the work with a written workmanship warranty. We serve Las Cruces and nearby communities including Sunland Park, Chaparral, Anthony, Santa Teresa.
What We Handle
Everything our fascia & soffit in Las Cruces covers
One crew, one point of contact, and the full range of fascia & soffit work in Las Cruces, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair Las Cruces
- soffit repair NM
- rotted fascia board replacement
- fiber cement fascia
- vented soffit installation
- aluminum fascia wrap
- soffit vent blocked insulation
- drip edge fascia detail
- fascia paint checking sun
- mobile home eave rail repair
- soffit panel replacement
- fascia and soffit cost
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Las Cruces services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with HUD-code roof pans re-seamed with embedded reinforcing fabric, silicone restoration membrane applied at 22 to 26 dry mils, roof-mounted evaporative cooler curbs with base and counter flashing, 29-gauge exposed-fastener panel refastened to oversize diameter screws, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Las Cruces job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Mesilla Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Las Cruces
Las Cruces Premium Roofing covers Las Cruces and the surrounding communities of the Mesilla Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Sunland Park, NM — Dona Ana County, population 16,702
- Fascia & Soffit in Chaparral, NM — Dona Ana County, population 16,551
- Fascia & Soffit in Anthony, NM — Dona Ana County, population 8,693
- Fascia & Soffit in Santa Teresa, NM — Dona Ana County, population 5,044
- Fascia & Soffit in University Park, NM — Dona Ana County, population 3,007
- Fascia & Soffit in Vado, NM — Dona Ana County, population 2,930
Start on the Las Cruces Premium Roofing homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Las Cruces Chooses Las Cruces Premium Roofing
- ✓We settle the recover question with a core cut before quoting, so you learn whether New Mexico's rewritten reroofing rule permits a second layer on your roof or forces a full tear-off.
- ✓We price manufactured home roofs as restoration work first, because a sound factory metal pan cleaned, re-seamed and coated is a warranted roof at a small fraction of a replacement.
- ✓We say where our license stops. Structural work on a HUD-code home answers to the Manufactured Housing Division, and framing changes answer to a framing or general building classification, not to a roofing license.
- ✓We diagnose leaks by controlled water testing rather than waiting for weather, because a roof here gets tested on roughly 24.5 days a year and a defect can hide for a season.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Las Cruces follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Las Cruces gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Las Cruces, or request a quote and we'll get right back to you.